Can be used for sport, touring and commuting applications
Works well in wet conditions as well as in cold brake conditions
Withstands abrupt temperature changes allowing for a quick feet return
Galfer Advance Ceramic Full Metallic HH Compound:
Will withstand friction ratings of 0.7u and does not require any heat to deliver friction
Advanced ceramic technology allows for pads to "cool off" as soon as pressure is released from the brake lever
Requires very little brake pressure effort under repeated braking
Recommended to those looking for the "edge" or "ultimate" stopping feel and control
Galfer strongly recommends following these BED-IN directions:
1. Clean the brake rotor(s) with thin sand paper and water prior to new pad installation
2. Towel dry the rotor surface after sanding
3. Install the new pads and be easy with the brakes for the next 40-50 miles
Galfer Sport Bike Wave Rotors
US Patent 6,386,340
Laser cut from a unique high-carbon 420 stainless steel that has been pre-heat treated and parallel double disc ground to assure perfect flatness
Sport bike front rotors are full-floating with an aluminum center carrier
Wave rotors will improve the lever feel and feedback allowing the rider to get a much stronger and progressive brake than other units would (added trailing edge on the brake pad surface)
Rotors sold individually
Note: All Galfer brake pads must be properly "BEDDED-IN" to achieve maximum output and reduce unnecessary rotor wear.
